基于LS -DYNA公路桥车桥耦合的车辆模型研究

研究公路桥梁在移动车辆荷载作用下的动力响应,建立合理的车辆模型非常重要。为更真实地体现桥梁在车载作用下的动力响应,基于LS-DYNA程序,结合常用重型车辆的结构特性及参数,对车辆的橡胶轮胎、轮胎内气体压力、车轮转动和车辆悬架系统进行模拟,使车辆模型更接近实际车辆。通过车辆轴重和动力特性初步验证车辆有限元模型的有效性;同时,以一座混凝土简支空心板梁桥为算例,验证车轮转动和车桥相互接触力,并将LS-DYNA计算结果与桥梁实测结果进行对比,进一步验证车辆有限元模型的有效性。研究结果表明,基于LS-DYNA建立的三维车辆有限元模型是可行的,可以用于研究车桥相互作用。     

GaInP/GaAs/Ge三结太阳电池不同能量质子辐照损伤模拟

以GaInP/GaAs/Ge三结太阳电池为研究对象,开展了能量为0.7, 1, 3, 5, 10 MeV的质子辐照损伤模拟研究,建立了三结太阳电池结构模型和不同能量质子辐照模型,获得了不同质子辐照条件下的I-V曲线,光谱响应曲线,结合已有实验结果验证了本文模拟结果,分析了三结太阳电池短路电流、开路电压、最大功率、光谱响应随质子能量的变化规律,利用不同辐照条件下三结太阳电池最大输出功率退化结果,拟合得到了三结太阳电池最大输出功率随位移损伤剂量的退化曲线.研究结果表明,质子辐照会在三结太阳电池中引入位移损伤缺陷,使得少数载流子扩散长度退化幅度随质子能量的减小而增大,从而导致三结太阳电池相关电学参数的退化随质子能量的减小而增大.相同辐照条件下,中电池光谱响应退化幅度远大于顶电池光谱响应退化幅度,中电池抗辐照性能较差,同时中电池长波范围内光谱响应的退化幅度比短波范围更大,表明中电池相关电学参数的退化主要来源于基区损伤.     

Development of low concentrated solar photovoltaic system with lead acid battery as storage device

Energy storage system powered by renewable energies is a viable option to meet energy requirement without addition of carbon footprints to the environment. This study involves development of theoretical and computational models for a solar photovoltaic (PV) system coupled with a lead acid battery. The study commenced with selection of most appropriate lead acid battery and PV system for installation in a representative location in Riyadh, Kingdom of Saudi Arabia. Various technical and economic parameters were assessed and calculated by computational approach. The optimized lead acid battery was integrated with low concentration solar PV panels (CPV) followed by a feasibility study. Theoretical model was developed for the integrated system to calculate various parameters of the CPV and lead acid battery. Technical and economic assessment of this coupled unit was calculated using a theoretical approach. The developed model was then subjected to computational approach for verification and validation analysis of the integrated system. The detailed assessment of batteries and integrated system show the applicability of this system in Riyadh region. The research will be extended to develop energy storage systems for remote areas using lead acid batteries.     

稳定分层湍流中逆梯度输运的关联分析研究

本文采用关联分析方法研究了稳定温度分层湍流中的结构特性、输运特性，以及热量、动量逆梯度输运现象的尺度效应及其参数演化．首先采用大涡模拟方法对稳定分层湍流中的结构特性和输运特性进行了分析，将逆梯度输运发生的时间尺度作为已知条件，结合关联量分析方法在波数空间中的解析解，对逆梯度输运现象的尺度效应进行了分析研究．结果发现，稳定分层强度较大的流动中发生垂向热量及动量逆梯度输运现象，发生的结构尺度与关联分析所发现垂向热量、动量逆梯度输运的波数形成了呼应．随着分层强度增加，热量、动量的输运强度均受抑制，与逆梯度输运关联的流场结构尺度减小，同样的效应也发生在流场结构向下游演化的过程中．     

宽体液腔Janus-Helmholtz换能器

本文使用有限元方法对宽体液腔Janus-Helmholtz(JH)换能器进行了仿真分析,得出了壳体宽度拓展增量对JH换能器工作性能的影响规律。使用三维建模的方式,分析了连接部分对换能器性能的影响及宽体壳体的的模态,证明了三维建模的必要性。依据仿真优化结构设计了一款宽体液腔JH换能器并进行了湖上测试。最终测试结果与仿真结果有很好的一致性,相较直筒JH换能器其谐振频率降低300Hz,发射电压响应最高可达144dB。     

Identifying the viscoelastic properties of soft matter from the indentation response of a hard film-soft substrate system

The indentation technique is widely used in measuring the mechanical properties of soft matter at the microscale or nanoscale,but still faces challenges by these unique properties as well as the consequent strong surface adhesion, including the strong nonlinear effect, unclear judgment of the contact point, difficulties in estimating the contact area, and the risk of the indenter piercing the sample. Here we propose a two-step method to solve these problems: lay a hard film on a soft matter, and obtain the viscoelastic properties of this soft matter through the indentation response of this composite structure. We first establish a theoretical indentation model of the hard film-soft substrate system based on the theory of plates, elastic-viscoelastic correspondence principle and Boltzmann superposition principle. To verify the correctness of this method, we measure the mechanical properties of the methyl vinyl silicone rubber(MVSR) covered by a Cu nanofilm. Finally, we test the effectiveness and error sensitivity of this method with the finite element method(FEM). The results show that our method can accurately measure the mechanical properties of soft matter, while effectively circumventing the problems of the traditional indentation technique.     

基于NICE-OHMS技术进行大气压气样直接检测的理论分析

噪声免疫腔增强光外差分子光谱技术(NICE-OHMS)是目前世界上最灵敏的激光吸收光谱技术,其在低压环境中具有极高的探测灵敏度。然而当测量样品处于大气压时,NICE-OHMS系统的探测灵敏度会大幅下降。主要原因之一是大气压下获取最大NICE-OHMS信号幅度的条件与低气压下不同。通过对大气压NICE-OHMS理论进行分析,分析了影响信号幅度的参数,并通过数值模拟来寻找最佳的实验条件。本文着重讨论影响信号的主要参数包括光学腔腔长L,调制系数β,探测相位θ。其中,由于在NICE-OHMS中使用DeVoe-Brewer技术将调制频率ν_m锁定到Fabry-Parot(FP)腔的自由光谱区(FSR)。因此FP腔的腔长决定了ν_m,同时还作用于信号幅度S■。模拟结果显示,当腔长增大时,由于ν_m随之减小,载波和边带的光谱成分相互重叠部分增大,因此线型函数的幅度逐渐减小。而吸收信号幅度随着腔长的增加而逐渐增加,色散信号幅度先增大后减小,并且在腔长等于8 cm时达到最大值。调制系数β会影响频率调制后激光载波和边带的幅度大小,并且影响信号线型。随着腔长的增加,最大信号幅度对应的β值也随之增加。在相同腔长下,色散信号的最佳β值小于吸收信号,更容易使用电光调制器实现。最后分析了参数的可实现性,分析了不同种类激光器的频率调谐能力,压电陶瓷的扫描宽度等。以乙炔气体为例,大气压下NICE-OHMS的谱线半宽达到~3 GHz,而光谱覆盖范围大于10 GHz。分布反馈式半导体激光器(DFB)与外腔二极管激光器(ECDL)的频率调谐范围可以达到30 GHz以上,但是由于激光线宽宽,得到的PDH锁定性能欠佳。回音壁模式激光器(WGM)和掺饵光纤激光器(EDFL)线宽为百Hz量级,是目前高灵敏NICE-OHMS系统中常用的光源。但是WGM目前可以实现了5 GHz的激光频率调谐范围,而EDFL的外部电压可控制的调谐范围仅为3 GHz。使用精细度为55000的腔进行模拟,调制系数β=1,腔长大于8 cm时,可使用WGM激光器实现,腔长大于25 cm时,可以使用EDFL激光器实现。而对于在设计光学腔中常用的伸缩长度为25μm的PZT,随着腔长的增加,对应的腔模频移范围逐渐减小,在腔长为典型的40 cm时,扫描范围大于12 GHz。     

干式变压器有限元仿真模型的电磁和振动分析

随着电力需求的逐年增长,干式变压器的数量也在不断增加。干式变压器在运行时存在着振动和噪声的问题,为了对干式变压器振动的规律与特点进行研究,本文建立了干式变压器本体振动的有限元仿真模型,通过电磁分析获得相应的磁场分布,然后利用结构动力学分析得到其本体振动的相关规律。通过对处于运行状态的变压器振动数据进行实测分析,得到变压器振动的特征频率,然后对仿真结果进行对比分析,可以发现振动幅度与频率之间存在的关系。本文的研究结果可对干式变压器的减振降噪研究提供参考。     

Effect of additive length and chemistry on the morphology of blends of conjugated thiophenes and fullerene derivative acceptor molecules

Small molecule additives have been shown to increase the device efficiency of conjugated polymer (donor) and fullerene derivative (acceptor) based organic solar cells by modifying the morphology of the device active layer. In this paper we conduct a systematic study of how additives affect the donor‐acceptor morphology using molecular dynamics simulations of blends of thiophene‐based oligomers, mimicking poly(3‐dodecylthiophene) (P3DDT) or poly(2,2′:5′,2”‐3,3”‐didocyl‐terthiophene) (PTTT), and fullerene derivatives with additives of varying length and chemical functionalization, mimicking experimentally used additives like methyl ester additives, diiodooctane, and alkanedithiols. We find that functionalization of additives with end groups that are attracted to acceptor molecules are necessary to induce increased donor‐acceptor macrophase separation. In blends where acceptors intercalate between oligomer alkyl side chains, functionalized additives decrease acceptor intercalation. Functionalized additives with shorter alkyl segments increase acceptor macrophase separation more than additives with same chemical functionalization but longer alkyl segments. © 2015 Wiley Periodicals, Inc. J. Polym. Sci., Part B: Polym. Phys. 2015 , 53, 1046–1057     

Influence of packing on the vibrations of homogeneous bundles of C60 peapods

The non-resonant Raman spectra of homogeneous bundles of C₆₀ peapods (C₆₀ inserted in single-walled carbon nanotubes) are calculated in the framework of spectral moment method, together with a bond-polarizability model. The evolutions of the low wavenumber range of the Raman spectrum of homogeneous bundles of C₆₀ peapods as a function of the nanotube diameter and the size of bundles are discussed. The effect of the C₆₀ filling factor is investigated in detail. The results are compared to experimental Raman data measured on various samples of C₆₀ peapods.